See below for step-by-step instructions, followed by a video tutorial.

Megaphone’s AdLocator allows you to place ad insertion points into your podcast. There are three types of insertion points (Pre-Roll, Mid-Roll, and Post-Roll). You can insert as many ad points as you’d like, though most podcasts have a standard set of insertion points (such as 2 Pre-Rolls, 2 Mid-Rolls, 1 Post-Roll). The key benefit of placing insertion points versus recording ads as part of your episode is that you have the ability to change out the ads later - keeping your inventory fresh and ultimately unlocking more revenue potential (also known as dynamic ad insertion).

1) Find the AdLocator

You can find the AdLocator by navigating to an episode or draft episode page. You find the episode page by navigating to your Podcast library (click on the Podcast tab on the left side), select your show, and then by clicking on the relevant episode or draft. In the top right you’ll see this button:

Click on “ADLOCATOR” to open up the AdLocator for that particular episode.

2) Place ad insertion points

Ad insertion points tell Megaphone where ads can be inserted into your episodes. Because there are three types of insertion points (Pre, Mid, and Post) there are three ways to place the insertion points. 

To ad a Pre or Post-roll, you can simply click on those buttons and they will be added to the start and end of your audio file:

For Mid-roll ad locations, you can click directly in the lower waveform to insert. The top, smaller waveform shows your entire audio file. Clicking throughout will adjust which portions are displayed in the lower waveform:

Another option to add Mid-roll ad locations is to use list a specific timestamp:

3) Adjust or increase your ad insertion points

Once you’ve placed your insertion points you can modify their exact placement. You can do this by dragging them around the waveform. For example, you may want to have your Pre-Roll start 10 seconds into the episode as opposed to having the Pre-Roll start immediately at the beginning.

You can also add multiple insertion points to the same location by increasing the number from one to your desired amount (2 in the example below).

4) Hit “Save” and you’re done! 

5) Deleting an ad insertion point
If you no longer want an ad insertion point, you can delete it by simply clicking the "X" on the colored bar:

 

 

Did this answer your question?